JWrap Insulation

asphalt-plant-insulation-banner-bw.jpg

Hot Oil Jumpers

Hot oil jumpers are often left uninsulated by other insulators. Using our flexible product, watch how we easily wrap a hot oil jumper and flange.
 

(START VIDEO DIALOG)

Voice of Ray Braun, Energy Advisor
Energy Reduction Solutions
 

What we are doing is using an 8" wide insulation material that is commonly used on inline flanges. However, what we are going to do is use it to wrap an 1 1/2" hot oil pipe.

If I had my preference, I'd use a little wider product – but for the purpose of this demonstration, we're using what we have available. Ideally a little larger piece of material would be our choice, but this is a demo and it does fit. Continued...

For Insulation Product Sales:

Watch Other Insulation Videos:
•  Hot Pipe Connections

•  Flexible Hoses

"All I care about is how much money I can save your asphalt plant and how quickly you see the return on your investment... generally 9 months."

– Ray Braun

WE PROVIDE

Insulation Services

We specialize in designing, installing, and consulting hot mix clients, and others, on industrial plant insulation systems that will save significant amounts of fuel.

Material sales

Design recommendations

Energy audits & fuel savings estimates

Installation by skilled installers

benefits-jwap-insulation.png
 

As I said… this is a demonstration. If we had larger product, we would use the larger product.

 

This type of hot oil jumper is often left uninsulated by other insulators because they don't have the materials to do this. As you can see, it has illuminated a safety issue as well as an efficiency issue.

We are going to wrap the other side, and we're going to wrap the flange.

The temperature is 158 degrees to the left of the flange. On the insulated portion, to the right of the flange, it's 86 degrees. So the surface temperature has been reduced by approximately 170 degrees.

This is a radius pipe with welded elbows. If this was a straight section of inch and a half pipe it would fit better than what this particular test or sample piece would fit, due to the radius.

We are going to insulate the flange right now. This product is significantly less expensive that a factory made or factory fabricated removable, reusable cover. It might cost as much as $85 to $100 to purchase just an inline flange cover. We're doing it for a little less.

What we like to do here, is to place the seam in a water shed position and also put the seam at about 5:00 and down low for best appearance.

It's nice, you can actually make the flange covers up in advance. You can make them all the same length and staple the ends. Rather than cutting each individual one on-site, you can do it ahead of time which would speed up the application.

This may not be extremely sophisticated but it is cost effective and versatile. In the event that you want to access the area, the insulation is easily removed.

Most importantly, it's quick!

Let's see what the surface temperature is. That's approximately 64 degrees, so we've reduced the surface temperature by about 200 degrees.

(END VIDEO DIALOG)

hotter-asphalt-insulation-bw.jpg

Insulate your facility for hotter oil and asphalt

asphalt-plant-insulation-bw.jpg

Insulate your asphalt plant for a fuel savings of $20+ per foot*

* Reference Theoretical Energy Savings Information

asphalt-plant-safety-bw.jpg

Insulate your hot pipes for a safer workplace and facility

Energy Reduction Solutions

753 B Avon Belden Road
Avon Lake, OH 44012

  • Energy Reduction Solutions
  • YouTube

© 2020 Energy Reduction Solutions.  All rights reserved.